Solar for textile mills in Tamil Nadu: how it cuts your power bill

Why textile units are a good fit for solar

Solar panels produce power during daylight. If your machines run through the day, most of the solar power is used directly in your plant instead of being exported, which gives the strongest savings. Mills with large, flat shed roofs also have plenty of space for panels.

What we check before designing a system

• ·Your last twelve months of electricity bills, to understand seasonality and demand.
• ·Sanctioned load and contract demand, which limit how much capacity can be installed.
• ·Roof condition and remaining sheet life. Putting solar on a roof that needs replacement soon is an expensive mistake.
• ·Shading from chimneys, water tanks, neighbouring buildings and roof equipment through the full day.
• ·Electrical layout, so the plant connects safely to your existing panel and protection.

Three ways to fund a solar plant

1. CAPEX: you buy and own the system. This gives the highest long-term saving and lets you claim the depreciation benefit.
2. OPEX or RESCO: a developer funds and maintains the plant on your roof, and you buy the power at an agreed rate with little or no upfront investment.
3. Open access: if your roof is too small for your load, you can buy solar power generated at a remote plant and wheeled to your unit through the grid.

Accelerated depreciation

Under the Income Tax Act, solar assets qualify for accelerated depreciation, which lets a business write off a large share of the cost faster than normal assets. The exact benefit depends on your tax position, so please confirm the numbers with your chartered accountant.

Payback and savings

Commercial solar is usually planned for a payback of a few years, with the exact figure depending on your tariff, your daytime load and the funding model. We start every enquiry by studying your bills and give you a clear estimate rather than a headline promise.

Our work with industrial roofs

We have completed commercial rooftop solar for textile and processing machinery in Erode, and we offer both EPC and annual maintenance (AMC) so the plant keeps performing for years.